Preparation and Characterization of Bhant Leaves‐derived Nitrogen‐doped Carbon and its Use as an Electrocatalyst for Detecting Ketoconazole

In this study, the electrocatalytic characteristics of nitrogen‐doped carbon (NDC) prepared from Clerodendrum Infortunatum L leaves on a glassy carbon electrode (GCE) surface was evaluated with regards to its ability to detect the electroactive drug ketoconazole (KCZ). The NDC was prepared by carrying out a simple pyrolysis of dry powder of the leaves at 850 °C. The prepared NDC was characterized using field‐emission scanning electron microscopy, energy dispersive spectroscopy, transmission electron microscopy, X‐ray photoelectron spectroscopy and Brunauer‐Emmett‐Teller analysis, and was then used as an electrode material. The performance of the electrochemical KCZ sensor with the NDC‐modified glassy carbon electrode (NDC/GCE) was found to be optimal when using PBS buffer at pH 3 and a concentration of 0.1 mg/ml of NDC in the conjugate with Nafion polymer. Under these conditions, the NDC/GCE displayed a KCZ detection limit of 3 μM and a linear dependence of its response on KCZ concentration over a wide range of KCZ concentrations from 47 μM to 752 μM (R²=0.9742). These results confirmed the potential of NDC as an electrocatalyst.     

The impact of insecticides containing deltamethrin and cyfluthrin on the composition of surface compounds in the larvae,females and males of Tenebrio molitor

This paper presents the effect of insecticides on the composition of the surface compounds of one of the most harmful insects, Tenebrio molitor, by analysis using GC–MS. As a result of the use of insecticides, the composition of the chemical compounds on the surface of insects changes, depending on the insecticides used. The most numerous groups of the marked compounds were fatty acids, alkanes, esters and sterols. The content of the identified compounds in the larvae increased at both 24 and 48 h after the application of insecticides, in comparison with the control samples. The content of identified compounds in the samples taken from the females increased 24, 48 and 72 h after the application of insecticides in comparison with the control samples. By contrast, in samples prepared from males, the content of identified compounds decreased 24 h after the application of insecticides, compared with the control samples. The highest content of chemical compounds was for fatty acids and alkanes after the use of insecticides. The content of fatty acids after the application of the insecticide with deltamethrin was 62.1 ± 3.3–466.9 ± 5.9 μg/g, and after the application of the insecticide with cyfluthrin was 49.9 ± 1.9–458.3 ± 4.2 μg/g. However, the content of alkanes after the use of deltamethrin was 115.6 ± 4.2–4672.0 ± 32.1 μg/g, and after the use of cyfluthrin was 189.4 ± 3.8–3975.0 ± 10.2 μg/g.     

Versatile Near-Infrared Super-Resolution Imaging of Amyloid Fibrils with the Fluorogenic Probe CRANAD-2

CRANAD-2 is a fluorogenic curcumin derivative used for near-infrared detection and imaging in vivo of amyloid aggregates, which are involved in neurodegenerative diseases. We explore the performance of CRANAD-2 in two super-resolution imaging techniques, namely stimulated emission depletion (STED) and single-molecule localization microscopy (SMLM), with markedly different fluorophore requirements. By conveniently adapting the concentration of CRANAD-2, which transiently binds to amyloid fibrils, we show that it performs well in both techniques, achieving a resolution in the range of 45–55 nm. Correlation of SMLM with atomic force microscopy (AFM) validates the resolution of fine features in the reconstructed super-resolved image. The good performance and versatility of CRANAD-2 provides a powerful tool for near-infrared nanoscopic imaging of amyloids in vitro and in vivo.     

White and some colored marbles as alternative radiation shielding materials for applications

ABSTRACT

In this paper, the radiation shielding parameters such as linear attenuation coefficients (LAC, µ), mass attenuation coefficients (MAC, µ/ρ), effective atomic numbers (Z_eff), effective electron densities (N_eff), half value of layers (HVL), mean free paths (MFP) and buildup factors (exposure (EBF) and energy absorption (EABF)) were investigated for cream (M1), pink (M2), white (M3), maroon (M4) and green (M5) marbles. Attenuation coefficients were measured in the energy region 31.18–661.66 keV photon energies. The values of Z_eff and N_eff were then calculated using these coefficients with logarithmic interpolation method, and HVLs and MFPs were calculated using the values of LAC of marble samples at the same photon energies. The experimental results were compared with the theoretical values obtained from WinXCom program, and good agreements were observed between the experimental and theoretical results. HVLs and MFPs of all marble samples were compared with those of some concretes, glasses and commercial radiation shielding glasses (SCHOTT Co.). The studied marbles were better radiation shielding materials than standard shielding concretes due to lower HVL and MFP values lower than the ordinary concrete. Finally, EBFs and EABFs of the marbles were calculated in the energy region 0.015–1?MeV up to penetration depths of 40 mfps by Geometric Progression method (G-P), and the results were discussed in terms of photon energies and chemical compositions of the marbles.     

Engineering nanostructures of CuO-based photocatalysts for water treatment: Current progress and future challenges

Nowadays, increasing extortions regarding environmental problems and energy scarcity have stuck the development and endurance of human society. The issue of inorganic and organic pollutants that exist in water from agricultural, domestic, and industrial activities has directed the development of advanced technologies to address the challenges of water scarcity efficiently. To solve this major issue, various scientists and researchers are looking for novel and effective technologies that can efficiently remove pollutants from wastewater. Nanoscale metal oxide materials have been proposed due to their distinctive size, physical and chemical properties along with promising applications. Cupric Oxide (CuO) is one of the most commonly used benchmark photocatalysts in photodegradation owing to the fact that they are cost-effective, non-toxic, and more efficient in absorption across a significant fraction of solar spectrum. In this review, we have summarized synthetic strategies of CuO fabrication, modification methods with applications for water treatment purposes. Moreover, an elaborative discussion on feasible strategies includes; binary and ternary heterojunction formation, Z-scheme based photocatalytic system, incorporation of rare earth/transition metal ions as dopants, and carbonaceous materials serving as a support system. The mechanistic insight inferring photo-induced charge separation and transfer, the functional reactive radical species involved in a photocatalytic reaction, have been successfully featured and examined. Finally, a conclusive remark regarding current studies and unresolved challenges related to CuO are put forth for future perspectives.     

Explicit H1-Estimate for the Solution of the Lamé System with Mixed Boundary Conditions

In this paper we consider the Lamé system on a polygonal convex domain with mixed boundary conditions of Dirichlet-Neumann type. An explicit L² norm estimate for the gradient of the solution of this problem is established. This leads to an explicit bound of the H¹ norm of this solution. Note that the obtained upper-bound is not optimal.     

平板几何迁移算子的特征值问题

研究L^p(1相似文献   

无绝缘高温超导双饼线圈的瞬态电热特性分析

无绝缘高温超导线圈具有良好的电热稳定性和机械紧凑性,但其充电过程中却有明显的磁场延迟现象。为详细了解无绝缘高温超导线圈励磁过程的瞬态特性,建立了无绝缘高温超导线圈的同轴圆环等效电路模型。通过绕制一个670匝的无绝缘高温超导双饼线圈,在液氮温度下进行不同充电速率的励磁实验,初步验证了等效电路模型的正确性。基于该模型,针对线圈励磁过程的充电和恒流阶段,仿真得到了线圈各匝的径向电流分布规律和电热损耗特性。     

Eigenvalues of a Differential Operator and Zeros of the Riemann $\zeta$-Function

The eigenvalues of a differential operator on a Hilbert-Pόlya space are determined. It is shown that these eigenvalues are exactly the nontrivial zeros of the Riemann $\zeta$-function. Moreover, their corresponding multiplicities are the same.     

Turing patterns for a coupled two-cell generalized Schnakenberg model

ABSTRACT

We consider a system for a generalized Schnakenberg model, showing Turing pattern formation for a wide class of nonlinearities.